isaiahwatt6
isaiahwatt6 isaiahwatt6
  • 15-01-2021
  • Engineering
contestada

Which control would be used to manually feed a cutting tool longitudinally across the workpiece?​

Respuesta :

IamSugarBee
IamSugarBee IamSugarBee
  • 15-01-2021

The carriage handwheel is used to manually position and/or hand feed the carriage in the longitudinal or Z axis.

IamSugarBee

Answer Link

Otras preguntas

Which of the following is an antonym for objective? A purposeful B credible C original D biased
Geographers rank human settlements based on what two factors? A. population and size by area B. size by area and impact/importance to the region C. population a
were the colonists satisfied with the articles of confederation
Which of the following is equal to 1/5^-2 Answers---A=1/25, B= -1/25, C=25, D=1/7
which word best describes the tone of emperor qian long's letter
Was the reign of terror necessary? Why?
Maria is erecting a statue on a triangular plot of land. She wants to put decorative stonework edging around the site. The length of one side of the plot of lan
What is the solution of log4x − 10^32 = 5? x = −2 x = 2 x = 3 x = 4
Suppose you wanted to study the historiography of ancient Greece. Which of the following actions would you take? A. Study the ways the Greeks recorded histor
Their are 45 questions on allison's english test. The multiple choice is worth 2 points each and the short answer is worth 5 points each. The entire test is wor